"EdgeRouter X SFP" 修訂間的差異
出自 CH 維基百科
| 行 50： | 行 50： | ||
#save | #save | ||
#exit | #exit | ||
| + | '''Restart pppoe''' | ||
| + | #sudo su - | ||
| + | #disconnect interface pppoe0 | ||
| + | #connect interface pppoe0 | ||
於 2020年8月11日 (二) 10:02 的修訂
註:前方有$#為CLI指令
IPv6 of Hinet pppoe P.S. eth0為WAN $sudo su #configure #set interfaces ethernet eth0 pppoe 0 ipv6 enable #set interfaces ethernet eth0 pppoe 0 ipv6 address autoconf #set interfaces ethernet eth0 pppoe 0 dhcpv6-pd pd 0 #set interfaces ethernet eth0 pppoe 0 dhcpv6-pd pd 0 prefix-length 64 #set interfaces ethernet eth0 pppoe 0 dhcpv6-pd pd 0 interface switch0 #set interfaces ethernet eth0 pppoe 0 dhcpv6-pd pd 0 interface switch0 service slaac #set interfaces switch switch0 ipv6 router-advert prefix ::/64 #commit #save #exit #reboot #y
硬體加速 #configure #set system offload hwnat enable #commit #save P.S.建議重啟
Port Forwarding WAN interface pppoe0 Auto firewall no Enable LAN interface swtch0 Firewall Policies WAN_IN 新增規則:Basic頁面->Action->Accept Destination頁面->輸入port
PPPOE Relay #sudo pppoe-relay -S eth0 -C switch0
UPnP Wizards -> UPnP Internal interface:switch0 External interface:pppoe0 UPnP2 $sudo su #configure #set service upnp2 wan pppoe0 #set service upnp2 listen-on switch0 #set service upnp2 listen-on eth1 #set service upnp2 nat-pmp enable #set service upnp2 secure-mode enable #commit #save #exit Restart pppoe #sudo su - #disconnect interface pppoe0 #connect interface pppoe0
